© 2012 Hobbico®, Inc. All rights reserved. FLZA4020 FLZA4022 MnlLength:38.5 in[980mm]Radio:5-channelradio systemMotor:40mm dia.850kV outrunner,40A ES
10❏ 2. Guide the wires from the right wing into the fuselage, then slide the wing joiner tube and the fl ap pushrod wire through the corresponding hole
11Hook Up the Flaps and Ailerons❏ 1. Connect the wing lighting wires and the aileron servo wires to the lighting and fl ap wiring harnesses coming from
12❏ 4. With the system still on, make sure the ailerons are centered and aligned with the wing tips. If necessary, apply a few clicks of aileron trim
13Recommended Control Surface ThrowsINCHESELEVATORLOW RATEHIGH RATE5/16"Up5/16"Down7/16"Up7/16"DownAILERONS3/8" 3/8"1/2&
14❏ 1. Mark the forward and aft C.G. limits on both sides of the bottom of the wing 2" and 2-1/2" [51mm and 64mm] back from the leading edge
15● Keep all loose clothing, long hair or any other loose objects such as pencils or screwdrivers that may fall out pockets away from the propeller.M
16It’s also a great idea to use a LiPo battery checker (HCAP0275) to check the battery before each fl ight (to make sure you haven’t inadvertently grab
2INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Academy of Model Aeronautics . . . . . . . . . . . . . . . . . . 2SA
3We, as the kit manufacturer, provide you with a top quality, thoroughly tested kit and instructions, but ultimately the quality and fl yability of you
4Parts may also be ordered directly from Hobby Services by calling (217) 398-0007, or via facsimile at (217) 398-7721, but full retail prices and ship
5ASSEMBLYNOTE: This instruction manual applies to both the RTF and Tx-R editions of the de Havilland Beaver. If assembling the RTF edition, simply ski
6❏ 2. Use eight M2.5x8 screws to fasten the braces to the fl oats, matching the labels printed or molded into the end of each brace to each mount locat
7❏ 2. Connect the elevator pushrod to the bottom hole in the elevator horn as shown.❏ 3. Rotate the stab upward and key it into the fuselage.❏ 4. Key
8❏ 5. Secure the stab and fi n with the M3x22 screw.Install the Battery❏ 1. Cut two 1" [25mm] strips from the rougher, “hook” side of the included
9single, lower tone beep (“BEEEP”) followed by a shorter, higher tone beep (“beep”). If the chimes and beeps do not sound in this manner refer to “MOT
Comments to this Manuals